PELECTRON AS
Outline
Polymer-Alloy Type Permanent Antistatic Agent for Styrene Resins (Low-Resistivity)
Features
· Polymer-alloy type permanent antistatic agent for styrene resins which were developed by using an original Sanyo Chemical compatibilization technique.
· This product imparts a permanent antistatic property to styrene resins such as ABS resin and PC/ABS resin by being kneaded into them as well as causing practically no degradation of their physical properties and moldability. In addition, compared to conventional permanent antistatic agents, PELECTRON AS exhibits an excellent antistatic property even when used in small amounts because this product substantially decreases surface resistivity of styrene resins.
· Imparts excellent antistatic property to ABS resin when the additive amount is between 5 and 15 wt %. It prevents from dust (surface resistivity value: the range of 10¹² to 10¹³ Ω) and exerts electrostatic dissipative properties to protect electronic parts and circuits (surface resistivity value: the range of 10⁸ to 10⁹ Ω).
· Exhibits a permanent antistatic property immediately after molding and the antistatic properties in the resulting plastic remain mostly unchanged even after being washed with water because it is a high-molecular-weight antistatic agent. In addition, it works even in low humidity due to its low dependency on humidity.
· Minimally affects the mechanical properties and moldability of the resins themselves.
· Applicable to electric and electronic parts because it contains almost no halogen ions such as chlorine ions or alkali metal ions.
Functions
- ・Antistatic
Applications
- ・Automobiles
- ・Electrics/Electronics Parts
- ・Synthetic Resins & Rubbers
Properties, and other information
| Principal Component | Polyether-ester-amide block copolymer | Appearance | Pale yellow pellet | Melting Point（℃） | 195 |
| Standard Dosage（phr） | 5-15（wt %） | Applicable resin | ABS resins, HIPS resins, PBT resins, nylon resins and PC／ABS alloys（Mainly injection molding） | Melt flow rate（10min） | 30（215℃）（ASTM D 1238（Measured under a load of 21.18N）） |
| Surface Resistivity（Ω） | 4×106（ASTM D 257） | Thermal degradation temperature（℃） | 285（JIS K 7120（TG-DTA, in the air）） |
Precaution Against Mishandling
· In the case of using PELECTRON AS at molding temperatures below 200 ℃ (392 °F), this product may not fuse, resulting in poor effectiveness. Furthermore, in case of using PELECTRON AS at molding temperatures above 300 ℃ (572 °F), this product may thermally decompose, resulting in poor effectiveness. The recommended molding temperature is between 210 and 250 ℃ (410 – 482 °F).
· Depending on the kind of resin, this product may have a negative effect on the resin's physical properties including mechanical properties. Test the effects on each of the physical properties beforehand to ensure that there are no problems.
Other Precautions
Avoid moisture absorption or water stained to protect this product from deterioration.
The color may gradually fade when exposed to light. Also, depending on the storage conditions,etc., it may be colored red in rare cases.
Before handling this product, refer to the current Safety Data Sheet for recommended protective equipment, and detailed precautionary and hazards information.If SDS is not listed on the homepage, please contact our sales representative.
